CL TYPE S V6-3.2L SOHC (2001)
12.
Start the engine, and let it warm up to its normal operating temperature. Make sure all electrical items are turned off and the steering wheel is
centered.
13.
While watching the PGM Tester or HDS, slowly turn the air bleed screw until the IAC count reaches 7 or you have turned the screw
counterclockwise a total of 3-1/2 turns.
^
If you see an IAC count of 7, turn the screw clockwise 1/2 turn, and then go to step 14.
^
If you do not see an IAC count of 7, leave the screw set at 3-1/2 turns. Go to step 14. You should never set the air bleed screw
counterclockwise more than 3-1/2 turns from its seated position. If you set the screw further, it could work itself out of the throttle body over
time.
14.
Let the engine idle for 10 minutes to allow the ECM/PCM to learn the new idle parameters.
15.
Turn the ignition switch to LOCK (0). Turn off and disconnect the PGM Tester or HDS.
Disclaimer
