CL TYPE S V6-3.2L SOHC (2001)
YES - Go to step 12.
NO - Repair the open in the wire between the inspection connector and G401, and recheck for DTCs.
6. One second after you go into self-diagnosis mode 1, the ignition key light and beeper indicate the DTC, and repeat it every three seconds. If there
is more than one DTC, the system will indicate them in ascending order, beginning from the DTC with the lowest numerical value. Find your DTC
in this table, then go to step 8 and check the communication lines.
7. With the ignition switch OFF, check for continuity according to the table.
Is there continuity?
YES - Go to step 8.
NO - Check for an open in the wire.
8. Turn the ignition switch ON (II), and check for voltage between the communication line and ground.
Does the voltage match the table?
YES - Communication lines are OK. Go to step 9.
NO - Repair the line according to the following.
-
If the voltage is too high:
-
Check for a short to another wire.
-
Check for poor contact in the connector at the receiving unit.
-
If the voltage is too low:
-
Check for a short to ground or to another wire.
-
Check for poor contact at the connector on the transmitting unit.
-
Faulty circuit in the transmitting unit.
9. Shift to the sleep mode:
-
Turn the ignition switch OFF.
-
Cancel the key-off operation timer in the power window system by opening and closing one of the doors.
-
Make sure that the exterior lights are off. If you do not operate any switches related to the multiplex control units within one minute after
meeting the above conditions, the system function shifts to the sleep mode. (All of the switches must be turned OFF except door lock knob
switches).
