CL TYPE S V6-3.2L SOHC (2001)
Air Bag Control Module: Testing and Inspection
Initializing the OPDS (Occupant Position Detection System) Unit
Special Tools Required
SCS service connector 07PAZ-0010100
When a seat-back cover, seat-back cushion, and/or OPDS unit is replaced, initialize the OPDS by following the procedure below.
NOTE: Make sure the front passenger's seat is dry. Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.
1. Make sure the ignition switch is OFF.
2. Connect the Honda PGM Tester(A) to the DLC(16P) (1), and follow the Tester's prompts in the "SCS" menu to ground the SCS line (see the
Honda PGM Tester Operator's Manual).
3. Connect the SCS service connector (B) to the MES connector (2P) (2). Do not use a jumper wire.
4. Turn the ignition switch ON (II).
5. The SRS indicator comes on for about 6 seconds and goes off. Remove the SCS service connector from the MES connector within 4 seconds after
the SRS indicator went off.
6. The SRS indicator comes on again. Reconnect the SCS service connector to the MES connector within 4 seconds after the SRS indicator comes
on.
7. The SRS indicator goes off. Remove the SCS service connector from the MES connector within 4 seconds.
8. Watch the SRS indicator.
-
If the indicator blinks two times and then stays on, the OPDS is initialized, but the DTCs need to be erased. Go to step 9, then erase the DTCs.
-
If the indicator blinks two times and then goes off, the OPDS unit is initialized. Go to step 9.
-
If the indicator stays on without first blinking, the OPDS is not initialized. Read the DTC. If DTC 15-1 is indicated, repeat the initialization
procedure. If an other DTC is indicated, go to the appropriate DTC Troubleshooting Index.
9. Turn the ignition switch off, and disconnect the PGM Tester.
