CL TYPE S V6-3.2L SOHC (2001)
8. Remove the bolts, then remove the seat belt guide (A).
9. Disconnect the seat belt tensioner connector (A) and seat belt tension reducer connector (B). Remove the upper anchor cap (C), upper anchor bolt
(D), the retractor mounting bolt (E), and the retractor bolt (F). Remove the front seat belt (G) and retractor (H).
10. Install the seat belt and retractor in the reverse order of removal, and note these items:
-
Apply liquid thread lock to the upper anchor bolt before reinstallation.
-
Check that the retractor locking mechanism functions.
-
Assemble the washers, collar and bushing on the upper and lower anchor bolts as shown.
-
Before installing the anchor bolts, make sure there are no twists or kinks in the front seat belt.
-
Make sure the seat belt tensioner connector and the seat belt tension reducer connector are plugged in properly.
-
When installing the mounting bolts for the middle cross-member gusset (A), torque the mounting hardware in the following sequence shown. If
the mounting bolts are not torqued in this sequence, damage to the quarter panel will occur.
-
Reconnect the negative cable to the battery.
-
Enter the anti-theft code for the radio, then enter the customer's radio station presets.
