CL TYPE S V6-3.2L SOHC (2001)
Impact Sensor: Service and Repair
Side Impact Sensor Replacement
Removal
NOTE:
-
Removal of the side impact sensor must be performed according to the precautions/procedures described previously.
-
Before disconnecting the side impact sensor 4P connector(s), disconnect the side airbag 2P connector(s).
-
Do not turn the ignition switch ON (II) and do not connect the battery cable while replacing the side impact sensor.
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Remove the seat assembly.
3. Remove the rear side trim panel.
4. Turn up the carpet, then remove the two-turn clips (A) and the plate (B),
5. Disconnect the side wire harness 4P connector from the side impact sensor.
6. Remove the two Torx bolts (A) using a Torx T30 bit, then remove the side impact sensor (B).
Installation
NOTE:
-
Be sure to install the harness wires so they are not pinched or interfering with other parts.
-
Do not turn the ignition switch ON (II) and do not connect the battery cable while replacing the side impact sensor.
1. Install the new side impact sensor with new Torx bolts (A) then connect the side wire harness 4P connector (B) to the side impact sensor (C).
