CL TYPE S V6-3.2L SOHC (2001)
Alignment: Customer Interest
Repair Procedure A
NOTE:
Do this repair procedure if, after doing step 10 of the test-drive, the vehicle pulled in the opposite direction after you swapped the front tires.
1.
Swap tires 2 and 4 on the passenger's side of the vehicle, and test-drive again.
^
If the pull goes away, replace tire 2, then go to step 3.
^
If the pull does not go away, put tires 2 and 4 back to their original positions, and go to step 2.
2.
Swap tires 1 and 3 on the driver's side of the vehicle, and test-drive again.
^
If the pull goes away, replace tire 1, then go to step 3.
^
If the pull does not go away, use a known-good tire in position 1 and continue the diagnosis.
3.
Use your diagnostic worksheet to fill in the table and build your 15-digit DTC.
