CL TYPE S V6-3.2L SOHC (2001)
8.
Remove the castle nut, then lift and support the knuckle (to prevent damaging the ABS sensor wire harness). Press the shaft all the way out of the
hub.
9.
Lift the knuckle, then place a block of wood (about 2-3/4" x 1-1/2" x 5") between the upper control arm and the damper assembly.
10.
Remove the boot from the lower ball joint.
11.
Clean the recessed area around the ball joint with solvent and compressed air, then install base remover adapter C.
12.
Hold remover/installer adapter A up to the ball joint, then install the castle nut to hold it in place. Install the remaining special tools on the lower
ball joint and the knuckle. To avoid damaging the special tools, verify that they are correct for the vehicle and are properly aligned.
13.
Tighten the C-Frame, and press the lower ball joint out of the knuckle.
14.
Position the new ball joint in the knuckle. Do not remove the boot from the ball joint.
