CL TYPE S V6-3.2L SOHC (2001)
Rear Knuckle Alignment Link: Service and Repair
Knuckle Replacement
Special Tools Required
Ball joint remover, 28 mm 07MAC-SL00200
1. Remove the hub bearing unit.
2. Remove the lock pin (A) from the upper arm ball joint, and remove the castle nut (B).
3. Disconnect the upper arm ball joint from the knuckle using the special tool.
4. Remove the wheel sensor from the brake backing plate. Do not disconnect the wheel sensor connector.
5. Remove the 8 mm flange bolts (A) and ABS sensor harness bracket from the knuckle.
6. Remove the damper mounting flange bolts (B) from the knuckle.
7. Remove the flange bolt and parking brake cable bracket (A) from the trailing arm (B).