CL TYPE S V6-3.2L SOHC (2001)
2. Loosely install the flange bolt (A) and nut (B) of the stabilizer link.
3. Raise the rear suspension with a floor jack until the vehicle just lifts off the safety stand.
4. Tighten the flange bolt at the bottom of the damper to the specified torque.
5. Tighten the flange nut of the stabilizer link ball joint to the specified torque while holding the joint pin (C) with a hex wrench (D).
6. Tighten the two flange nuts on top of the damper to the specified torque.
7. Install the rear shelf.
8. Install the rear wheels.
9. Set the rear wheel alignment.
