CL TYPE S V6-3.2L SOHC (2001)
12. Apply primer (3M N-200, or equivalent) to the areas between the alignment marks (A), then apply the adhesive tape (B) (NITTO 501, or
equivalent) to the edge of the windshield. Be careful not to touch the windshield where adhesive will be applied.
13. Glue the molding (A) with adhesive tape (3M 4212, or equivalent) (B) to the edge of the windshield (C):
-
Be sure the alignment mark (D) of the molding lines up with the alignment mark (E) of the windshield.
-
Be careful not to touch the windshield where adhesive will be applied.
