CL TYPE S V6-3.2L SOHC (2001)
7.
Cut six pieces of tubing from the washer tubing roll. Use the measurements from the appropriate CL or TL washer tubing diagram.
8.
Using a razor knife, carefully cut the old tubing at the washer nozzles, the check valves, the "Y" joint, and the elbow joint.
9.
Replace each section of tubing with the tubing you cut in step 7. Make sure to route the new tubing correctly, using all existing clips, joints, and
fittings. Also, make sure you install the washer nozzle check valves in the direction as shown.
NOTE:
To help with assembly, dip the tubing in clean washer fluid before passing it through clips and pressing the ends onto fittings, joints, and nozzles.
10.
3.2CL only: Install new washer clips and cushion tape.
11.
Replace any hood insulator clips that broke when you removed the insulator, then install the insulator.
12.
Install the inner fender and the wheel. Torque the lug nuts to 108 Nm (80 lb-ft).
13.
Fill the washer reservoir with commercially available washer fluid.
14.
Replace the wiper blades.
