Integra L4-1590cc 1.6L DOHC FI (1987)
Clutch: Technical Service Bulletins
M/T - New Clutch Replacement Parts
December 19, 1988
BULLETIN NO. 88-017
YEAR 1986-1988
MODEL INTEGRA
VIN APPLICATION ALL
New Clutch Replacement Parts
New clutch components improve durability under stop-and-go driving conditions.
CORRECTIVE ACTION
Replace the clutch friction disc and pressure plate with the new parts listed under Parts Information.
WARNING:
Inhaled asbestos fibers have been found to cause respiratory disease and cancer. Never use an air hose or dry brush to clean the clutch assembly. Use
an OSHA-approved vacuum cleaner or alternate method approved by OSHA, designed to minimize the hazard caused by airborne asbestos fibers.
1.
Replace the clutch set, using the procedure outlined in the Service Manual.
2.
Replace the clutch release bearing as part of this procedure (standard part).
3.
Adjust the clutch pedal free-play to specifications.
Note:
^
The new clutch set (disc and pressure plate) called for in this bulletin must be installed as a unit. Combining either of these new components with
the original clutch disc or pressure plate will cause harsh clutch action, chattering, and short service life.
^
Clearly note on the repair order that new part number clutch components have been installed. Tell the customer to retain this information so the
proper components can be installed if any future clutch work is needed.
^
Clutch pedal free-play is critical to clutch life. The decreased free-play that results from normal wear of the friction disk can eventually cause
slippage, which accelerates the wear. After installation of this new clutch set, show the customer how to periodically check the free-play at the
pedal during normal operation, and emphasize that the car must be returned for adjustment of the free-play if it becomes minimal.
PARTS INFORMATION
Clutch Set:
P/N 22105-PC6-A00
WARRANTY INFORMATION
The normal warranty applies. If the warranty has expired, this repair is eligible for goodwill consideration by the District Service Manager. You must
request consideration, and get the DSM's decision, before starting the work.
