Integra L4-1678cc 1.7L DOHC (VTEC) FI (1992)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Removal and Installation
Modulator Unit
Caution
-
When removing the modulator unit or after removing it, be careful not to turn it upside-down or lean it excessively.
-
Do not spill brake fluid on the car; it may damage the paint; if brake fluid does contact the paint. wash it off immediately with water.
-
Take care not to damage or deform the brake pipes during removal and installation.
-
To prevent the brake fluid from flowing, plug and cover the hose ends and joints with a shop towel or equivalent material.
-
Do not loosen the relief plug on the accumulator.
Removal:
1. Disconnect the modulator unit and pump motor connector.
2. Remove the wire harness clips from the modulator bracket.
Note: When a new harness clip is installed after a wire harness or modulator unit replacement, adjust the harness band to the dimensions shown in
image.
3. Remove the three 8 mm nuts, and remove the modulator unit from the bracket.
Note: When the pump motor or the modulator unit is replaced, bleed the high-pressure brake fluid first.