Integra L4-1678cc 1.7L DOHC (VTEC) FI (1992)
3. Use circlip pliers to remove the snap ring B, then remove the pulley.
4. Remove the snap ring A and the field coil.
5. Install in the reverse order of removal and:
^ Install the field coil with the wire side facing up (see above).
^ Clean the pulley and compressor sliding surfaces with non-petroleum solvent.
^ Check the pulley bearings for excessive play.
^ Make sure the circlip is fitted to the groove properly.
^ Apply locking agent to the thread of the center bolt and tighten it securely.
^ Make sure that the pulley turns smoothly.