Integra L4-1678cc 1.7L DOHC (VTEC) FI (1992)
_fi/Page-1677003.png)
9.
Remove the ignition coil and igniter mounting screws. Remove the coil and igniter from the distribution
^
If the vehicle has less than 30,000 miles, continue to step 10 to pack grease in the bearing.
^
If the vehicle has more than 30,000 miles, go to step 18 to replace the distributor housing.
10.
Use a two-jaw puller to remove the cylinder sensor rotor from the distributor shaft. Make sure the jaws are placed under the inner part of the rotor
and not on the projection. Watch the roll pin on the inside of the rotor next to the shaft. It should slide off with the rotor; if it does not, do not let it
fall inside the distributor housing.
11.
Use a small punch to remove the roll pin from the cylinder sensor rotor. Discard the roll pin.
12.
Cut the corner off the bag of grease that came in the distributor cap kit. Fill the well above the shaft bearing with this grease; distribute it evenly.
13.
Use a piece of hose to pack the grease into the bearing. The hose should have an inner diameter of 1/2 inch (12.5 mm) and an outside diameter of
