Integra L4-1678cc 1.7L DOHC (VTEC) FI (1992)
Constant Velocity Joint Boot: All Technical Service Bulletins
Drivetrain - Creaking Noise While Turning
92-009
February 1, 1999
Creaking Noise While Turning
(Supersedes 92-009, dated February 7, 1995)
** Indicates updated information **
Black bars in illustrations indicate updated information.
SYMPTOM
A clicking noise is heard while making right or left turns at 10 mph or less.
PROBABLE CAUSE
^
Worn outboard driveshaft joint.
^
The outboard driveshaft joint boot has split, allowing contamination to enter the joint and damage it.
** CORRECTIVE ACTION
Replace the noisy outboard driveshaft joint. **
WARRANTY CLAIM INFORMATION
In warranty:
The normal warranty applies.
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Technical Manager or your Zone Office. You
must request consideration, and get a decision, before starting work.
Defect code:
042
Contention code:
B07
Failed part:
Use the replacement part number
Skill level:
Repair Technician
PARTS INFORMATION
** Refer to the Parts Catalog or Parts Information Bulletin 95-0004 for the appropriate outboard joint kit application and part number.
REQUIRED SPECIAL TOOLS
Threaded Adapter:
T/N 097XAC-001010A; 22 mm
T/N 07XAC-001020A; 24 mm
T/N 07XAC-001030A; 26 mm **
DIAGNOSIS
(Driving Method)
1.
Drive the car in a circle in an open parking lot at approximately 10 mph with the brakes lightly applied.
2.
Have an assistant stand in the center of the circle and listen for the clicking noise.
3.
Drive the car in the opposite direction. The assistant should be able to tell which axle is making the noise.