Integra L4-1678cc 1.7L DOHC (VTEC) FI (1992)
Mainshaft: Service and Repair
Disassembly and Reassembly
NOTE: The 3rd/4th and 5th synchro hubs are installed with a press. Prior to reassembling, clean all the parts in solvent, dry them and apply lubricant to
any contact surfaces. The 3rd/4th and 5th synchro hubs, however, should be installed with a press before lubricating them.
Disassembly
CAUTION: Remove the synchro hubs using a press and steel blocks as shown. Use of a jaw-type puller can cause damage to the gear teeth.