Integra L4-1678cc 1.7L DOHC (VTEC) FI (1992)
Inspection
1. Inspect the surface and bearing surface for wear and damage, then measure the mainshaft at points A, B, and C.
Standard:
A: 27.977-27.990 mm (1.1015-1.1020 in)
B: 37.984-38.000 mm (1.4954-1.4960 in)
C: 27.987-28.000 mm (1.1018-1.1024 in)
Service Limit:
A: 27.930 mm (1.0996 in)
B: 37.930 mm (1.4933 in)
C: 27.940 mm (1.1000 in)
If any part of the mainshaft is less than the service limit, replace it with a new one.
2. Inspect for runout.
Standard: 0.02 mm (0.001 in)
Service Limit: 0.05 mm (0.002 in)
NOTE: Support the mainshaft at both ends as shown.
If the runout exceeds the service limit, replace the mainshaft with a new one.
Reassembly
CAUTION:
-
Press the 3rd/4th and 5th synchro hubs on the main-shaft without lubrication.
-
When installing the 3rd/4th and 5th synchro hubs, support the shaft on steel blocks and install the synchro hubs using a press.
-
Install the 3rd/4th and 5th synchro hubs with a maximum pressure of 20 kN (2,000 kg, 4,400 lbs).