Integra L4-1678cc 1.7L DOHC (VTEC) FI (1992)
Reverse Idler Gear: Testing and Inspection
Reverse Shift Fork, Reverse Idler Gear Clearance Inspection
1. Measure the clearance between the reverse shift fork and 5th/reverse shift piece pin.
Standard:
Reverse Side: 0.05-0.45 mm (0.002-0.018 in)
5th Side:
0.40-0.90 mm (0.016-0.035 in)
2. If the clearance exceeds the standard, measure the width of the groove in the reverse shift fork.
Standard:
Reverse Side: 7.05-7.25 mm (0.278-0.285 in)
5th Side:
7.40-7.70 mm (0.291-0.303 in)
Note: If the width of the groove exceeds the standard, replace the reverse shift fork with a new one. If the width of the groove is within the
standard, replace the 5th/reverse shift piece with a new one.