Integra (GS-R) L4-1797cc 1.8L DOHC (VTEC) (1994)
/l4-1797cc_1.8l_dohc_(vtec)/Page-3384001.png)
Impact Sensor: Service and Repair
DASH SENSOR REPLACEMENT
CAUTION:
-
Do not damage the sensor wiring.
-
Do not install used SRS parts from another car, When repairing an SRS: use only new parts.
-
Replace a sensor if it is dented, cracked, or deformed.
NOTE: The original radio has a coded theft protection circuit. Be sure to get the customer's code number before disconnecting the battery cables.
1. Disconnect the battery negative cable and then the positive cable.
2. Remove the glove box damper (see section 20), then remove the glove box.
3. Connect the short connector(s) to the airbag(s).
4. Remove the footrest driver's side only and door sill molding, then pull the carpet back, and remove the dash sensor protector. (Left side shown;
right side is similar.)
