Integra (RS, LS) L4-1834cc 1.8L DOHC PFI (1995)
/l4-1834cc_1.8l_dohc_pfi/Page-439001.png)
Cruise Control Switch: Testing and Inspection
Set/Resume/Cancel Switch
1. Obtain five digit radio theft protection code system as outlined under Vehicle Damage Warnings, then remove dashboard lower cover and knee
bolster.
Fig. 22 Set/Resume/Cancel Switch Test Harness
2. Disconnect cable reel harness 6 pin connector from SRS main harness, then connect Test Harness C or equivalent as shown, Fig. 22, to cable reel
side of connector.
Fig. 23 Set/Resume/Cancel Switch Test Harness Continuity Inspection
3. Check for continuity between terminals of test harness as shown, Fig. 23, in each switch position. If continuity exists as specified, switch is
operating properly.
