Integra GS-R L4-1797cc 1.8L DOHC (VTEC) PGM-FI (2001)
7. Before installing the plastic cover, make sure the door harness and connectors are fastened correctly on the door.
8. Install the plastic cover and bracket.
NOTE:
-
Apply adhesive along the edge where necessary to maintain a continuous seal and prevent water leaks.
-
Do not plug the elongated hole.
9. Install the door panel.
NOTE:
-
Make sure the door harness is not pinched.
-
If necessary, replace any damaged clips.
-
Make sure the connectors are connected properly.
10. Install the armrest pocket and inner handle trim.