Integra GS-R L4-1797cc 1.8L DOHC (VTEC) PGM-FI (2001)
NOTE: When molding removal is difficult, cut the molding with a knife.
5. Pull down the rear of the headliner.
CAUTION: Take care not to bend the headliner excessively.
6. Apply protective tape to the edge of the body as shown.
Using an awl, make a hole through the adhesive from inside the car. Push the piano wire through the hole, and wrap each end around a piece of
wood.
7. With a helper on the outside, pull the piano wire back and forth in a sawing motion, and carefully cut through the adhesive around the entire rear
window.