Integra GS-R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (1997)
_mfi/Page-2980001.png)
Brake Rotor/Disc: Testing and Inspection
Disc Runout
1. Loosen the rear wheel nuts slightly, then raise the vehicle and support it on safety stands. Remove the rear wheels.
2. Remove the brake pads.
3. Inspect the disc surface for damage and cracks. Clean the disc thoroughly and remove all rust.
Measure Runout With Dial Indicator
4. Use wheel nuts and suitable plain washers to hold the disc securely against the hub, then mount a dial indicator as shown and measure the runout at
10 mm (0.4 in) from the outer edge of the disc.
5. If the disc is beyond the service limit, refinish the brake disc.
Specs:
Max. Refinishing Limit 8.0 mm (0.32 in)
NOTE: A new disc should be refinished if its runout is greater than 0.10 mm (0.004 in).
