acura Workshop Repair Guides

Acura (Honda) Workshop Service and Repair Manuals

Starting System - Can't Turn Key In Ignition Switch|Page 5931 > < Starting System - Can't Turn Key In Ignition Switch
Page 1
background image

Ignition Lock: Service and Repair

STEERING LOCK / REPLACEMENT

CAUTION:

- All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag connectors.
- Whenever the ignition switch is ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could

accidentally deploy and cause damage or injuries.

- For additional precautions, refer to the SRS section See: Restraint Systems/Service Precautions. 

NOTE:  The original radio has a coded theft protection circuit. Be sure to get the customer's code number before

-

disconnecting the battery.

-

removing the No. 32 (7.5 A) fuse from the under-hood fuse/relay box.

-

removing the radio.

After service, reconnect power to the radio and turn it on. When the word "CODE" is displayed, enter the customer's 5-digit code to restore radio
operation.

1. Disconnect the negative cable from the battery.
2. Remove the dashboard lower cover and knee bolster.
3. Disconnect the 5-P connector from the under-dash fuse/relay box and the 7-P connector from the main wire harness.
4. Remove the steering column covers.

5. Remove the column holder mounting bolts and nuts.
6. Lower the steering column assembly.

Starting System - Can't Turn Key In Ignition Switch|Page 5931 > < Starting System - Can't Turn Key In Ignition Switch