Integra GS-R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (1997)
_mfi/Page-3253004.png)
15. Press the cylinder end seal and steering rack out of the gearbox.
NOTE: Hold the steering rack to keep it from falling when pressed clear.
16. Remove the special tool and cylinder end seal from the steering rack.
17. Remove the 12 mm bolt and nut from the steering rack, then install a 24" long, 3/8" drive extension, and the special tool into the cylinder from the
gearbox side.
CAUTION: Be careful not to damage the inside surface of the housing with the tools.
18. Set the gearbox in a press, then press out the cylinder end seal and backup ring from the gearbox.
CAUTION:
-
Keep the tool straight to avoid damaging the cylinder wall. Check the tool angle, and correct if necessary, when removing the cylinder end
