Integra GS-R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (1997)
_mfi/Page-3254004.png)
20. Press the new roller bearing into the valve housing using a hydraulic press and special tools as shown.
NOTE: Place the roller bearing on the valve housing with its letter stamped facing up towards the valve side.
21. Apply vinyl tape to the pinion shaft, then coat the vinyl tape with power steering fluid.
22. Insert the pinion shaft into the valve housing.
CAUTION: Be careful not to damage the valve seal rings.
23. Remove the vinyl tape from the pinion shaft.
24. Press the pinion shaft/sleeve using a hydraulic press as shown.
CAUTION: Before inserting the pinion shaft, be sure that the backup ring is centered with the pinion shaft bearing.
