Integra GS-R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (1997)
_mfi/Page-3255003.png)
15. Disconnect the two lines from the valve body unit on the steering gearbox.
CAUTION: After disconnecting the hose and pipe, plug or seal the hose and pipe with a piece of tape or equivalent to prevent foreign materials
from entering the valve body unit.
NOTE:
-
Place the pipe disconnected in the previous step at the rear side of the gearbox so that they do not hinder in the gearbox removal.
-
Do not loosen the cylinder pipes A and B between the valve body unit and cylinder.
16. Remove the steering gearbox mounting bolts.
17. Pull the steering gearbox all the way down to clear the pinion shaft from the bulkhead, and remove the pinion shaft grommet.
18. Move the steering gearbox to the right so the left rack end clears the rear beam.
19. Hold the steering gearbox and slide the rack all the way to the left, then place the left rack end below the rear beam.
