Integra GS-R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (1997)
_mfi/Page-3256003.png)
13. Install the rear beam brace rod and return pipe clamp on the rear beam.
NOTE: Install the rear beam brace toward the return pipe clamp.
14. Install the three way catalytic converter. Refer to Exhaust System.
15. Connect the shift linkage. Refer to Transmision and Drivetrain.
16. Thread the right and left tie-rod ends onto the rack an equal number of turns.
17. Reconnect the tie-rod ends to the steering knuckles, tighten the castle nut to the specified torque, and install new cotter pins.
CAUTION: Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the pin hole. Do not align
the nut by loosening.
18. Install the front wheels.
