Integra GS-R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (1997)
_mfi/Page-3271001.png)
Ball Joint: Service and Repair
Ball Joint Replacement
Ball Joint Replacement
TOOL REQUIRED
-
07965-SB00100 Ball Joint Remover/Installer
-
07965-SB00200 Ball Joint Installer base
-
07974-SA50700 Ball Joint Boot Clip Guide
REPLACEMENT
1. Remove the steering knuckle.
2. Remove the boot by prying the set ring off.
3. Check the boot for deterioration and damage, replace if it is necessary.
4. Install the special tools on the ball joint and tighten the castle nut.
5. Position the special tools over the ball joint as shown, then set the assembly in a vise. Press the ball joint out of the steering knuckle.
6. Place the ball joint in position by hand.
7. Install the special tools over the ball joint as shown, then press the ball joint in.
