Integra GS-R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (1997)
-
In example (A), your measured tapered roller bearing preload was 2.0 Nm (18 inch lbs.) less than standard so you need a 79.5 mm shim
five sizes thicker than standard (try the 1.53 mm (0.0602 inch) shim and recheck).
-
In example (B) your's was 0.8 Nm (7 inch lbs.) more than standard, so you need a thrust shim two sizes thinner (try the 1.32 mm (0.0520
inch) shim and recheck).
10. After adjusting the tapered roller bearing preload, assemble the transmission, and install the transmission housing.
-
8 x 1.25 mm: 27 Nm (20 ft. lbs.).
11. Rotate the differential assembly in both directions to seat the tapered roller bearings.