Integra GS-R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (1997)
_mfi/Page-2788001.png)
Mainshaft: Testing and Inspection
Clearance Inspection
CLEARANCE INSPECTION
NOTE: If replacement is required, always replace the synchro sleeve and the synchro hub as a set.
1. Measure the clearance between 2nd and 3rd gears.
-
Standard: 0.06 - 0.21 mm (0.002 - 0.008 inch).
-
Service Limit: 0.3 mm (0.01 inch).
2. If the clearance is more than the service limit, measure the thickness of 3rd gear.
-
If the thickness of 3rd gear is less than the service limit, replace 3rd gear with a new one.
-
If the thickness of 3rd gear is within the service limit, replace the 3rd/4th synchro hub with a new one.
3. Measure the clearance between 4th gear and the spacer collar.
-
Standard: 0.06 - 0.21 mm (0.002 - 0.008 inch).
-
Service Limit: 0.3 mm (0.01 inch).
