Integra GS-R Sedan L4-1797cc 1.8L DOHC (VTEC) MFI (1999)
-
The tapered roller bearing and bearing outer race should be replaced as a set.
-
Inspect and adjust the tapered roller bearing preload whenever the tapered roller bearing is replaced.
-
Check the tapered roller bearings for wear and rough rotation. If tapered roller bearings are OK, removal is not necessary.
1. Remove the tapered roller bearings using a bearing puller and bearing separator as shown.
2. Install new tapered roller bearings using the special tool as shown.
NOTE: Drive the tapered roller bearings on until they bottom against the differential carrier.
OIL SEAL REMOVAL
1. Remove the differential assembly.