Integra GS-R Sedan L4-1797cc 1.8L DOHC (VTEC) MFI (1999)
4. Install the new thrust shim and 79.5 mm shim, then drive the bearing outer races in the both housings using the special tools as shown.
NOTE:
-
Install the bearing outer race squarely.
-
Check that there is no clearance between the bearing outer race, thrust shim, and transmission housing.
5. Install the oil seal.
TAPERED ROLLER BEARING PRELOAD ADJUSTMENT
NOTE: If any of the items listed below were replaced, the tapered roller bearing preload must be adjusted.
-
Transmission housing
-
Clutch housing
-
Differential carrier
-
Tapered roller bearing and bearing outer race
-
Thrust shim
1. Remove the bearing outer race, the thrust shim, and the 79.5 mm shim from the transmission housing.
CAUTION: Do not reuse the thrust shim if the bearing outer race was driven out.