Integra GS Coupe L4-1834cc 1.8L DOHC MFI (1997)
A/T Gear Position Indicator: Testing and Inspection
A/T Gear Position Indicator Input Test
A/T GEAR POSITION INDICATOR / INPUT TEST
CAUTION:
All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag connectors.
Whenever the ignition switch is ON, or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could
accidentally deploy and cause damage or injuries.
For additional precautions, refer to the SRS section See: Restraint Systems/Service Precautions.
Remove the gauge assembly from the dashboard and disconnect connectors "B", "C, and "D" from it. Inspect the connector terminals to be sure they are
all making good contact.
*
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
*
If the terminals look OK, make the following input tests at the connector.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, the gauge assembly must be faulty; replace it.
