Integra GS Coupe L4-1834cc 1.8L DOHC MFI (1997)
Shift Interlock Solenoid: Testing and Inspection
Shift Lock Solenoid Test and Replacement
SHIFT LOCK SOLENOID TEST AND REPLACEMENT
1. Shift Lock Solenoid Test/Replacement. Remove the console, then disconnect the 2-P connector of the shift lock solenoid from the main wire
harness.
NOTE: Do not connect power to the B (-) terminal (reverse polarity) or you will damage the diode in side the solenoid.
2. Connect battery power to the A terminal, ground the B terminal momentarily, and check solenoid operation.
*
If the solenoid does not operate, replace it as described in steps 3, 4, and 5.
*
If the solenoid does operate, check and, if necessary, adjust its two positions as shown in step 5.
3. Remove the shift lock collar and the solenoid pin.
4. Remove the self-locking nuts and shift lock solenoid, then install the new solenoid in the reverse order of removal.
5. Check and, if necessary, adjust the solenoid's position.
