Integra GS Sedan L4-1834cc 1.8L DOHC MFI (1999)
Turn Signal Switch: Testing and Inspection
COMBINATION LIGHT-TURN SIGNAL SWITCH / TEST
CAUTION:
All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag connectors.
Whenever the ignition switch is ON, or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could
accidentally deploy and cause damage or injuries.
For additional precautions, refer to SRS See: Restraint Systems/Air Bag Systems/Service Precautions.
1. Remove the dashboard lower cover and steering column covers.
2. Disconnect the 4-P and 7-P connectors from the switch.
3. Check the connector and socket terminals to be sure they are all making good contact. If the terminals are bent, loose, or corroded, repair them as
necessary, and recheck the system.