Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
ABS Pump Motor: Service and Repair
WARNING: The modulator unit contains high-pressure brake fluid Be sure to bleed the high-pressure fluid from the modulator unit before
removing the pump motor.
1. Bleed the high-pressure brake fluid from the modulator unit. See: ABS Modulator Unit/Service and Repair/Relieving System Pressure
2. Remove the modulator unit from the vehicle.
3. Remove the 8 mm flange bolts from the modulator unit, and remove the pump motor.
4. Install the pump motor in the reverse order of removal.
Specs:
Flange Bolt 15 Nm (11 lb. ft.)
NOTE:
-
After installing the modulator unit, add fresh brake fluid until the reservoir is refilled to the specified level, and bleed air from the system. See:
Brake Bleeding/Service and Repair/Bleeding Procedures
-
Turn the ignition switch ON and check for the ABS indicator light operation.