Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
Cam And Lever Assembly
2. Coat the new cam boot with grease and install it in the caliper body.
3. Apply grease to the pin contacting area of the cam and install the cam lever assembly into the caliper body.
4. Instal the return spring.
CAUTION:
-
When the cam and lever are separated be sure to assemble them before installing the cam in the caliper body. Install the lever and spring
washer, apply locking agent to the threads and tighten the parking nut while holding the lever with a vise.
-
Avoid damaging the cam boot since it must be installed before the cam.
-
When installing the cam do not allow the cam boot lips to turn inside out.
5. Install the pin in the cam.
6. Apply grease to the new O-ring and install it on the sleeve piston.
Sleeve Piston And Pin
7. Install the sleeve piston so the hole in the bottom of the piston is aligned with the pin in the cam and the two pins in on the piston are aligned with
the holes in the caliper.
8. Coat a new cup with grease and install it with its groove facing the bearing A side of the adjusting bolt.
