Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
Wear Indicator
12. Apply Molykote M77 grease to both sides of the shims. Wipe excess grease off the shims.
13. Install the brake pads and pad shims on the caliper bracket.
WARNING:
-
Install the pad with the wear indicator on the inside.
-
When reusing the pads, always reinstall the brake pads in their original positions to prevent loss of braking efficiency.
-
Contaminated brake discs or pads reduce stopping ability. Keep grease off the discs and pads.
Caliper Mounting Bolts
14. Rotate the caliper piston clockwise into the cylinder, then align the cutout in the piston with the tab on the inner pad by turning the piston back.
NOTE: Lubricate the boot with rubber grease to avoid twisting the piston boot. If the piston boot is twisted, back it out so it sits properly.
15. Install the brake caliper.
16. Install and tighten the caliper bolts while holding the caliper pins with a thin, open-end wrench.
17. Install the rear caliper protector.
18. After installation, check for leaks at hose and line joints and connections, and retighten if necessary.
19. Depress the brake pedal several times to make sure the brakes work, then road-test.
NOTE: Engagement of the brake may require a greater pedal stroke immediately after the brake pads have been replaced as a set. Several
applications of the brake pedal will restore the normal pedal stroke.