Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
Brake Pad: Testing and Inspection
Front
WARNING:
-
Never use an air hose or dry brush to clean brake assemblies
-
Use an OSHA-approved vacuum cleaner to avoid breathing brake dust.
1. Loosen the front wheel nuts slightly, then raise the vehicle and support it on safety stands. Remove the front wheels.
2. Remove the caliper bolt, and pivot the caliper up out of the way. Check the hoses and pin boots for damage and deterioration.
3. Remove the pad shims, pad retainers and pads.
4. Using vernier calipers, measure the thickness of each brake pad lining.
Measure Brake Pad Lining
NOTE: The measurement does not include the pad backing plate thickness.
Specs:
Brake Pad Thickness
Standard 9.5-10.5 mm (0.37-0.41 in)
Service Limit 1.6 mm (0.06 in)
5. If the brake pad thickness is less than service limit, replace the front pads and shims together as a set.
6. Clean the caliper thoroughly; remove any rust, and check for grooves and cracks.
7. Check the brake disc for damage and cracks.