Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
Brake Rotor/Disc: Testing and Inspection
Disc Thickness and Parallelism
1. Loosen the rear wheel nuts slightly, then raise the vehicle and support it on safety stands. Remove the rear wheels.
2. Remove the brake pads.
Measure Disc Thickness With Micrometer
3. Using a micrometer, measure disc thickness at eight points, approximately 45° apart and 10 mm (0.4 in) in from the outer edge of the disc.
Replace the brake disc if the smallest measurement is less than the max. refinishing limit.
Specs:
Brake Disc Thickness
standard 8.9 - 9.1 mm (0.35 - 0.36 in)
max Refinish Limit 8.0 mm (0.31 in)
Brake Disc Parallelism 0.015 mm (0.0006 in)
NOTE: This is the maximum allowable difference between the thickness measurements.
4. If the disc is beyond the service limit for parallelism, refinish the brake disc.
