Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
Brake Master Cylinder: Service and Repair
Master Cylinder Mounting Nuts And Brake Pipes
CAUTION:
-
Be careful not to bend or damage the brake lines when removing the master cylinder and brake booster.
-
Do not spill brake fluid on the vehicle it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
-
To prevent spills, cover the hose joints with rags or shop towels.
1. Disconnect the brake fluid level switch connectors.
2. Remove the reservoir cap from the master cylinder.
3. Remove the brake fluid from the master cylinder reservoir with a syringe.
4. Disconnect the brake lines from the master cylinder.
5. Remove the master cylinder mounting nuts and washers.
6. Remove the master cylinder from the brake booster.
7. Install in reverse order of removal
Specs:
Brake Line Flange Nuts 19 Nm (14 lb-ft)
Master Cylinder To Booster 15 Nm (11 lb-ft)
NOTE:
-
If replacing the master cylinder or brake booster, check and adjust the pushrod clearance before installing the master cylinder.
-
Adjust the pushrod length before installing the brake booster.
-
Bleed the brake system. See: Brake Bleeding/Service and Repair/Bleeding Procedures
