Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
Remove clips carefully; don't damage their locks.
Slip pliers under the clip base and through the hole at an angle, then squeeze the expansion tabs to release the clip.
After installing harness clips, make sure the harness doesn't interfere with any moving parts.
Keep wire harnesses away from exhaust pipes and other hot parts, from sharp edges of brackets and holes, and from exposed screws and bolts.
Seat grommets in their grooves properly.
Testing and Repairs
Do not use wires or harnesses with broken insulation. Replace them or repair them by wrapping the break with electrical tape.
After installing parts, make sure that no wires are pinched under them.
When using electrical test equipment, follow the manufacturer's instructions and those described in the service steps.
If possible, insert the probe of the tester from the wire side (except waterproof connector).
