Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
26. Using a cutter or an equivalent tool, cut the valve seal ring and O-ring at the groove the pinion shaft. Remove the valve seal ring and O-ring.
CAUTION: Be careful not to damage the edges of the pinion shaft groove when removing the valve seal ring and O-ring.
27. Remove the valve oil seal and backup ring from the pinion shaft.
NOTE:
-
Inspect the ball bearing by rotating the outer race slowly. If there is excessive play, replace the pinion shaft and sleeve as an assembly.
-
The pinion shaft and sleeve are a precise fit; do not intermix old and new pinion shafts and sleeves.
28. Press the valve oil seal and roller bearing out of the valve housing using a hydraulic press and special tool shown.