Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
36. Grease the steering rack teeth, then insert the steering rack into the gear housing.
CAUTION: Be careful not to damage to inner surface of the gear housing with the rack edges.
37. Set the gearbox in a press with the cylinder housing facing upward.
38. Install the flange bolt into the end of the steering rack until it bottoms in the hole, then back the flange bolt out 1/4 turn. Hold the flange bolt and
tighten the flange nut against the rack by hand.
39. Install the cylinder end seal into the bottom of the cylinder by pressing on the bolt with a press as shown.
CAUTION: Do not push on the bolt with excessive force; as it may damage the cylinder end seal.
40. Remove the special tool, and center the steering rack.
41. Install the special tool or vinyl tape onto the end of the steering rack, then coat the special tool or vinyl tape with power steering fluid.
42. Coat the inside surface of the new cylinder end seal with power steering fluid.
43. Install the cylinder end seal onto the steering rack with its grooved side toward the piston.
44. Remove the special tool. Push in the cylinder end seal with finger.
NOTE: Take care not to damage the cylinder end seal with the threads and burrs at the staked position of the gearbox.
