Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
6. Remove the TORX T30 bit bolts then, remove the airbag assembly.
7. Disconnect the connectors from the horn and cruise control set/resume switches.
8. Remove the steering wheel nut.
9. Remove the steering wheel by rocking it slightly from side-to-side as you pull steadily with both.
CAUTION:
-
Before installing the steering wheel, align the front wheels straight ahead.
-
Be sure to install the harness wires so that they are not pinched or interfering with other car parts.
-
Do not replace the original steering wheel with any other design, since it will make it impossible to properly install the airbag. (Only use
genuine Acura replacement parts.
-
After reassembly, confirm that the wheels are still straight ahead and that steering wheel spoke angle is correct. If minor spoke angle
adjustment is necessary, do so only by adjustment of the tie-rods, not by removing and repositioning the steering wheel.
WARNING: Confirm that the airbag assembly is securely attached to the steering wheel; otherwise, severe personal injury could result
during airbag deployment.
