Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
Case: Service and Repair
Mainshaft/Countershaft
TOOLS REQUIRED
-
07749-0010000 driver
-
07746-0010500 Attachment, 62 x 68 mm
-
07746-0010600 Attachment, 72 x 75 mm
-
Or Equivalent
1. To remove the mainshaft and countershaft bearings from the transmission housing, expand each snap ring with snap ring pliers, then push the
bearing out using the special tools and a press as shown.
NOTE: Do not remove the snap rings unless it's necessary to clean the grooves in the housing.
2. Expand each snap ring with snap ring pliers, insert the new bearing part-way into the housing using the special tools and a press as shown. Install
the bearing with the groove facing outside the housing.
NOTE: Coat all parts with ATF.