Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
Countershaft: Testing and Inspection
Component Inspection
1. Inspect the gear surfaces and the bearing surfaces for wear and damage, then measure the countershaft at points A, B. and C.
-
Standard:
A: 24.980 - 24.993 mm (0.9835 - 0.9840 inch).
B: 36.984 - 37.000 mm (1.4561 - 1.4567 inch).
C: 33.000 - 33.015 mm (1.2992 - 1.2998 inch).
-
Service Limit:
A: 24.930 mm (0.9815 inch).
B: 36.930 mm (1.4539 inch).
C: 32.950 mm (1.2972 inch).
-
If any parts of the countershaft are less than the service limit, replace countershaft with a new one.
2. Inspect for runout.
-
Standard: 0.02 mm (0.0008 inch) max.
-
Service Limit: 0.05 mm (0.002 inch).
NOTE: Support the countershaft at both ends as shown.
-
If the runout is more than the service limit, replace the countershaft with a new one.