Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
NOTE:
-
Use a straight edge and depth gauge.
-
Measure at three locations and average the readings.
6. Select the proper 72 mm thrust shim from the chart by using the formula.
NOTE: Use only one 72 mm thrust shim.
-
Shim Selection Formula: From the measurements you made in steps 4 and 5:
a. Add distance (C) (step 5) to distance (B) (step 4).
b. From this number, subtract 0.93 (which is the midpoint of the flex range of the clutch housing bearing spring washer).
c. Take this number and compare it to the available shim sizes in the chart
7. Check the thrust clearance in the manner described:
NOTE: Carry out the measurement at normal room temperature.
a. Install the thrust shim selected and oil guide plate in the transmission housing.
